Honeywell HZ-1350 Series, Important Safety Instructions Manual

4

CONSUMER RELATIONS

Questions or Comments

Call us toll-free at:

 1-800-477-0457 

E-mail:

 consumerrelations@kaz.com 

Or visit our website at: 

www.HoneywellPluggedIn.com/heaters

Please be sure to specify model number.

CLEANING AND STORAGE

We recommend that the heater be cleaned at least once a month and before off-season storage.
•  Before cleaning, or storage, or when not in use, turn the product’s controls to the OFF position and 

unplug the heater from the electrical outlet and allow to cool.

•  Use only a dry cloth to clean the external surfaces of the heater.   

DO NOT USE WATER, WAX, POLISH, OR ANY CHEMICAL SOLUTION.

•  Clean your heater using the above-mentioned steps, then pack the heater in its original container and 

store in a cool, dry place.

•  This heater does not disassemble.

TROUBLESHOOTING

If your heater shuts off unexpectedly or fails to operate, one of the above-mentioned safety features may 

have been activated to prevent overheating.
•  Be sure the power cord is plugged into a working electrical outlet.
•  Check your Thermostat setting. The unit may simply be off because you have reached your desired heat 

setting.

•  Check for any obstructions. If you find an obstruction, turn the heater OFF (•) and unplug it.
•  Allow the heater to cool completely, then remove the obstruction. Wait at least 10 minutes, then re-plug 

in the heater and follow the OPERATING INSTRUCTIONS for your unit.

SAFETY FEATURES

•  A high temperature safety control prevents overheating.
•  Equipped with a thermal cut-off fuse that will permanently shut down the heater should it operate at a 

higher than normal temperature.

• When an overheat temperature is reached, the heater will be automatically shut off. It can only resume 

operation when the user resets the unit. 

TO RESET

   • Unplug the heater and wait 10 minutes for the unit to cool down.

   • After the 10 minutes, plug the unit in again and operate normally.