ICON 100 SERIES INSTALLATION GUIDE
1. SAFETY INSTRUCTIONS
A. Keep this instruction booklet where it can always be easily consulted
by the operator or by maintenance personnel.
B. Warning: hot components may be inside the plastic housing of the
controller.
C. No user-serviceable parts are inside the plastic housing of the
controller.
D. The controller and any device connected to it must be installed in
compliance with the Safety Regulations in force. If these regulations
are not respected during installation, and if our product is not installed
in compliance with the indications given in this instruction booklet, then
this may cause a reduction in the safety level of the controller. In
particular, the ambient operating conditions for the controller given in
our technical data must be complied by; absolutely avoid: water
condensation or excessive humidity, exposure to steam, corrosive - or
toxic gases, contact with any type of liquid, and exposure to shocks or
to extreme vibrations. Not respecting the above indications could
cause malfunctions and entail unpredictable consequences, e.g., in the
worst cases, dangerous electrical discharges on probes or other parts
of the instrument.
EN1B-0004UK07 R1003
3
