Appendix B — Default Settings
PD43 and PD43c Commercial Printer User Manual
169
Wireless 802.11 Network Settings
This section describes the 802.11 IPv4 and IPv6 settings. To view these
settings:
•
From the printer Main Menu, select
Settings > Communications
> Wireless 802.11 > Network > IPv4
or
IPv6
.
•
From the printer web page, click the
Configure
tab,
Communications > Wireless 802.11
.
Wireless 802.11 Network Settings
Setting
Description
Default
(IPv4) IP
Assignment
Method
Sets how the printer obtains an IP
address (for IPv4 networks).
DHCP
(IPv4) IP Address Sets the unique network-level address
that is assigned to each device in an
IPv4 network.
0.0.0.0
Subnet Mask
Sets a number that defines the range of
IP addresses that can be used in an IPv4
network.
0.0.0.0
Default Router
Sets the IP address of a router that is
used when a device sends a packet to
another subnet or to an unknown
destination.
0.0.0.0
DHCP Response
Sets if the printer receives DHCP
responses by broadcast or unicast.
Broadcast
(IPv6) IP
Assignment
Method
Sets how the printer obtains an IP
address (for IPv6 networks).
Automatic
(IPv6) IP Address Sets the unique network-level address
that is assigned to each device in an
IPv6 network.
Automatic
Summary of Contents for Intermec PD43
