Honeywell IPGSM-DP, Installation And Setup Manual

IPGSM-DP Commercial Fire Communicator – Installation and Setup Guide

– 

2

 – 

STEP 1 – Activate the SIM and Setup the Customer Account 

The communicator requires a subscriber account (customer account) to be setup with AlarmNet Direct.  This 

is accomplished by registering the communicator's iGSM communications module with AlarmNet.  
Registering, enables the fire panel to send reports. 
To setup the customer account you will need to contact the central monitoring station to get account 

information, and have access to the AlarmNet Direct website.  To access the AlarmNet Direct website visit – 

https://services.alarmnet.com/AlarmNetDirect

If you do not wish to use the AlarmNet Direct website, you may call AlarmNet to setup the account, just 
phone 800-222-6525, then select option 1.  

(Monday–Friday 8:00 am to 9:00 pm, Saturday 9:00 am to 5:30 pm EST) 
Have the following information ready: 



Primary City ID (two digits), obtained from your 

monitoring station. 



Primary Subscriber ID (four digits), obtained 

from your monitoring station. 



Primary Central Station ID (two digits), obtained 

from your monitoring station. 



Communication Module's MAC ID, and MAC 

CRC number located on outside of box, and 

inside of the module. 

Note:

 The IPGSM-DP comes with a SIM (Subscriber Identity Module) that needs to be 

activated.   

1.

To activate the SIM, log into the AlarmNet Direct website and choose “SIM Activation/Status”, then 

enter the required information.  Click 

Activate SIM

. 

2.

Setup the customer account by choosing "Program New Device GSM/I", enter the required 

information.  When complete, click 

DONE

. 

STEP 2 – Register the Communications Module with AlarmNet 

Registering the module activates the account with AlarmNet and enables the fire system's control panel to 

send reports.  There are three methods that can be used to register the communications module. 



Register the module by logging into AlarmNet Direct and choosing “Show Programmed Devices 
GSM/I”.  Search for the account using the Account Information or MAC ID.  Under the “Actions” 

column, use the pulldown menu and choose Register.  OR 



After the IPGSM-DP is installed and programmed, you can register the module by clicking the 
Tamper Switch 3 times.  OR 



After the IPGSM-DP is installed and programmed, you can register the module using the 7720P 

Programming tool.  Simply: Press [Shift ] then press [



].  Please wait for "Registration SUCCESS" 

message.