LKS 310 Actuator for air dampers on multi-stage and modulating burners
www.honeywell.com
7
INSTALLATION
Safety Guidelines
1.Screw the housing cover securely in place to provide shock-
hazard protection on the actuator and all electrical connec-
tions.
2.Always lay the burner ignition cable separately and as remotely
as possible from the device and other cables.
3.Electromagnetic emissions must be checked on a case by
case basis.
COMMISSIONING AND INSPECTION
Safety Guidelines
Function control
For safety reasons the actuator should be tested on commission-
ing the installation as well as after a service or longer shut-down.
REPAIRING AND DISPOSAL
WARNING
• The regulations and standards applicable in each
particular case must be observed.
• Installation must only be carried out by qualified
technicians.
• Electrical wiring must comply with national and local
regulations.
• Disconnect the actuators completely from the
power supply when working close to terminals
and connections.
WARNING
• Commissioning and inspection may only be carried
out by qualified personnel.
• Carefully check all cabling and wiring prior to com-
missioning.
It is forbidden to do any repairing on actuator
LKS 310.
The distributor of the heating system assures the pro-
fessional disposol or the forwarding to the manufac-
turer for inspection.
EN1C-011
4SZ20 R05
06
