LTE-X Series Installation and Setup Guide
– 17 –
[S]
ECP Flt
OK
ECP Mode
Displays the mode of operation and system fault status.
Flt – Represents communicator faults:
OK = Normal, No fault.
G = No network connectivity over cellular network and fault time has expired.
g = No network connectivity over cellular network and fault time has NOT yet
expired.
[T]
Test Msg Sent
Test Alarm
Sends a Test alarm to AlarmNet. Functional for a
registered
communicator only. If
the device is not registered, a message is displayed indicating that the command
cannot be executed.
[X]
Reset CPU Y/N
Reset the communicator.
Pressing [N] returns to normal mode.
Pressing [Y] resets the device.
[Shift]
[
↑
]
(UP arrow)
Registering …
Registration
Registers a programmed communicator with AlarmNet.
[
↓
]
(DN arrow)
Enter PIN#
Registration with PIN for Replacement Module
Registers a replacement communicator with AlarmNet, once programmed, using the
existing PIN #.
[0]
Force Server
Update? Y/N
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire configuration file to the server.
Pressing [N] cancels the operation.
NOTE:
If the communicator is not initialized when you enter this command, the
following screen will be displayed:
Cannot Upload
Try Later! _
Wait for the SIGNAL (green) LED to light, indicating the communicator has
completed its initialization, and try again.
[ENTER]
Strt Prog Mode?
Y/N_
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].
