Rev. B
7-39
HMXMC001013
31-Mar-06
7.12 ETHERNET PORT, CONTINUED
The MAXPRO-Net server is connected to the Network node through Ethernet, where the
Network Node’s MAXPRO-Net server’s IP address 10.1.20.27 and device node 1.
MAXPRO-Net sends the commands to the Network Node (IP address 10.1.20.27)
through LAN.
7.13 VCR Management Tab
VCR management provides ‘one touch’ review of dedicated VCRs. While viewing a
camera, simply press the ‘Dedicated Review’ key and the appropriate VCR will be
automatically selected to the review monitor and be ready for instant review. Additional
operators may concurrently review the VCR where required for verification purposes.
Logging and standby VCRs are reviewable similarly.
Tape change operations may be automatically or manually initiated. The MAXPRO-Net
printer output provides a comprehensive audit trail of Tape change and standby VCR
allocation details.
7.13.1 Dedicated
VCR
The dedicated VCR1, VCR2, VCR 3…are defined in the dedicated VCR tab of SetMax.
These VCRs are connected to Bank 1. When the tape change sequencing is to be
initiated manually, the Manual Tape Change field is used to define the external alarm
input that will be used to begin Tape change operations on this bank. Upon entry of a
value into this field, SetMax will automatically add the appropriate definitions to the
‘External Alarm Inputs’ table.
The range of valid entries is 1 – 9999, the default value is 0 indicating that the Tape
change operations are automatically initiated. When you have completed editing the
dedicated VCR properties page, click on the OK button.
