Rev. B
6-17
HMXMC001013
31-Mar-06
Video Outputs
The total number of video outputs allowed in a MAXPRO-Net
system is 999.
Sequence
Each video output device may be configured with any one of the 999
video scan sequences as a default scan sequence. Enter 0 if a default is
not required.
Note: If a scan sequence number greater than 100 is used, make sure
that it has been defined in the scan sequence table before booting the
MAXPRO-Net video environment.
Status
When a video output device is to automatically begin running a scan
sequence (at power-on), the scan status must be specified in this field.
Select 'Run' to automatically begin running the default scan sequence
number. Select 'Halt' if the default scan sequence specified should not
automatically start.
Output Lock
Video output devices may be locked to prevent changing to another
video input device. This field defines the default power up lock status for
the current video output device.
The lock status may be changed from the system menu using MaxMon
while MAXPRO-Net is running and via macro control.
Source Group
Each video output device may be granted access to any of the source
groups, which are allocated to every video input device. This allows the
system to control which video output channels have access to which
video inputs. Due to hardware restrictions some monitors may only be
able to access certain video inputs. Source groups are also used to
partition video input selections for specific operators.
When the Source Group field is selected, the field changes to a Display
Icon.
Click on the Display Icon to view the Output Source Access table.
Click on a check box to toggle the source group access state. Click on
the All button to toggle all check boxes. Click on the numbered button
(1, 2, 3, etc.) to the left of a horizontal row to toggle all the check boxes
in a horizontal row. Click on the numbered button (0, 10, 20, etc.) at the
top of a row of vertical check boxes to toggle all the check boxes in a
vertical row.
A check mark in the box indicates the video output device has access to
a source group.
Click OK to save changes. Click Cancel to exit the display without
saving changes.