. . . . .
C O N F I G U R I N G M A X P R O N V R
Recommendation to use Low bandwidth stream option
MAXPRO NVR 5.0 Installation and Configuration Guide
183
R e c o m m e n d a t i o n t o u s e L o w b a n d w i d t h
s t r e a m o p t i o n
Before enabling the Use Low resolution stream option in MAXPRO VMS you need to perform
the following:
1.
In
MAXPRO
NVR Camera tab > Primary/Secondary Stream > Preference
, select the
Secondary stream
from the
Low resolution
drop down.
Note:
Set the Primary stream for recording which is 720p resolution and secondary
stream for Live which is 4CIF.
2.
In
MAXPRO VMS > Preferences > Advanced Tab > Low Bandwidth Stream Settings
,
select the
Use Low Resolution Stream
check box.
The below table explains the parameter that you can set for Primary and Secondary Streams.
Primary /Main Stream
Secondary /Sub Stream
Codec Format
H.264B
H.264B
Resolution
720 P
(1280 x 720)
VGA
(640x480)
FPS
12
5
Bit Rate Type
CBR
CBR
Bit Rate
640 - 720
192
Summary of Contents for MAXPRO NVR Hybrid PE
