Procedural Considerations
Page 22
34-ST-25-20 MC Toolkit User Manual Release
3
9/06
Table 3 DE Main Menu Procedures
DE Main Menu Procedures
DE Main
Menu
(ST 3000)
(STT 3000)
Note:
This message appears if the
<
Back
button is selected if
the transmitter was set to
Output Mode (in Calibration
procedures), and the Output
was not later cleared.
Device
Info
Tag ID
(r/w)
User ID up to 8 alphanumeric characters (suggestion: relate
to functional process entities and/or plant areas).
Type
(r)
Manufacturer's device type identifier (typically, a model
number)
Firmware Version
(r)
Manufacturer's Firmware version identifier
Serial Number
(r)
Manufacturer
Scratch Pad
(r/w)
Up to 32 alphanumeric characters (suggestion: messages
to control room regarding observed/assigned operational
status)
General
(ST 3000)
(STT 3000)
PV Type
(r/w)
Select: Dual Range
(STDC) or Single Range or
Single Range w/SV
Communication Mode
(r/w) Select: Analog or DE
4 Byte or DE 6 Byte
FS Direction
(r)
(Upscale or Downscale;
selection is jumpered in the
transmitter).
Line Filter
(r)
Select: 50hz or 60hz.
T/C Fault Detect
(r/w):
Select: Enabled or
Disabled.
