ID2000 Series Installation & Commissioning Manual
Installation Guide
7
997-433-000-5, Issue 5
May 2010
2.4 Installation
The ID2000 Series of modular fire control panels are
relatively simple to install providing the recommended
procedures described in this Installation Guide are
followed.
Follow all installation instructions described in this
manual. These instructions must be understood and
the manufacturer’s recommendations followed to
avoid damage to the control panel and associated
equipment.
2.4.1 Checking Your Panel for Damage
It is important to check all supplied equipment for
damage before proceeding with the installation!
Before attempting to install the modular components of
your ID2000 Series control panel, or other equipment,
you should do the following:
1
After removing the various control panel modules or
other related equipment from its packaging, and
before you proceed with installing it in its chosen
location, check for any damage that may have
occurred while in transit.
Note:
In the unlikely event that any of the supplied ID2000
Series items has been damaged, you MUST NOT
fit it but return it to your supplier. The procedure
for returning faulty items is described in
Section
2.4.2
,
What to do if Your Module is Damaged or
Suspect
.
2
If you are satisfied that none of the supplied items
has been damaged you can now proceed with the
installation procedure. This manual addresses the
recommended installation methods of the various
ID2000 Series equipment components which are
supplied as separate build modules. Refer to the
relevant sections that apply to your configuration
requirements.
To prevent unnecessary damage to the electronic
components, the panel back box(es) should be installed
first, i.e. without fitting the main chassis at this stage.
Refer to
Section 2.4.3,
Back Box Fixing
for details.
To avoid damage to the
control panel ensure that
you follow these
instructions
1
2
Do a quality check
before proceeding with
the installation!
