NFS-320 and NFS-320SYS UL Listing Document —
P/N 52745LD:G9 5/19/2022
31
ESC/MN
TROUBLE MON
trouble
N
Indicates Trouble on a Mass Notification
device
Monitors mass notification devices. Will generate a trouble
condition for both open and short conditions.
ECS/MN
MONITOR
5
MNS alarm
Y
Does not light any LEDs, overrides existing
fire event, shuts off silenceable outputs and
all fire activated strobes and activates CBE.
Monitors mass notification devices
RF GATEWAY
non-alarm
Y
Activates CBE
Provides communication between wireless device and the
fire panel.
1 The Drill Switch type code should not be used for Canadian applications.
2 For Canada, the point type is alarm.
3 For proper PAS operation, a CGW-MB may not be installed on the network.
4 LED representation of a CO alarm may be performed using an ACS annunciator.
5 If ECS/MN Override is not selected in VeriFire Tools, fire events will take priority over ECS/MN audio events.
NOTE:
On a control module, the default zone is always set to Zone 00 (general alarm).
Type Code
Silenceable (Y/N) Configuration
Device Function
CONTROL
Y
NAC
Supervised NAC for notification appliance
RELAY
Y
Form-C relay
Relay output
BELL CIRCUIT
Y
NAC
Supervised NAC for notification appliance
STROBE CKT
Y
NAC
Supervised NAC for notification appliance
HORN CIRCUIT
Y
NAC
Supervised NAC for notification appliance
AUDIBLE CKT
Y
NAC
Supervised NAC for notification appliance
SPEAKER
Y
NAC
Supervised NAC for notification appliance
ISOLATED NAC
Y
NAC
Supervised NAC for notification appliance, used with audio isolators. Activates even if there is
a short on its NAC circuit. For ULC installations only.
ISOLATED SPK
Y
NAC
Supervised NAC for speaker circuits, used with audio isolators. Activates even if there is a
short on its audio circuit. For ULC installations only.
REL END BELL
N
NAC
Supervised NAC for notification appliance
blank
Y
NAC
Supervised NAC (for use when no other Type Code applies)
REL CKT ULC
1
N
NAC
Releasing Circuit, power-limited (Class 2), supervised for opens, shorts and ground faults
(always non-silenceable)
RELEASE CKT
1
N
NAC
Releasing circuit, non-power-limited, supervised for opens and ground faults
RELEA.FORM C
1
N
Form-C Relay
Relay output, contacts operate upon release
REL AUDIBLE
Y
NAC
NAC, activated upon release
NONRESET CTL
N
Form-C Relay
and NAC
Relay output, unaffected by “System Reset” command
TELEPHONE
N
NAC
Standard Telephone circuit
INSTANT RELE
1
N
NAC
NAC, short = normal; supervised for open circuits and ground faults. Always non-silenceable
and switch-inhibited.
ALARMS PEND.
N
NAC
Output that will activate upon receipt of an alarm condition, and remain in the alarm state until
all alarms have been acknowledged. It is programmed as “switch inhibit”.
CONTROL NAC
Y
NAC
Supervised NAC
GEN ALARM
N
NAC
Control Module, an XPC-8 circuit, or an XP5-C (in NAC mode) configured as a Municipal Box
Transmitter for NFPA 72 Auxiliary Fire Alarm Systems applications. This Type ID can also be
used for general alarm activation. It is programmed as “switch inhibit”.
GEN SUPERVIS
N
NAC
Control Module, an XPR-8 relay, or an XP5-C (in relay mode) activated under any Supervisory
condition (includes sprinkler type). It is programmed as “switch inhibit”.
GEN TROUBLE
N
NAC
Control Module, an XPR-8 relay, or an XP5-C (in relay mode) activated under any System
Trouble condition. It is programmed as “switch inhibit”.
GENERAL PEND
N
NAC
Control Module, an XPC-8 circuit, or an XP5-C (in NAC mode) that will activate upon receipt of
an alarm and/or trouble condition, and remain in the ON state until all events have been
ACKNOWLEDGED.
Table 9 Control Module Type Codes (1 of 2)
Table 8 Monitor Module Type Codes (2 of 2)
Walk Test Selection: *=off
(default); W=selected
Silenceable: O =selected; *=off (default)
Default zone
Blinking Type Code selection
CBE list
(five zones)
12 spaces for extended
custom label
SLC number (1 or 2)
M (module)
SLC address (001-159)
Switch Inhibit: I=selected; *=off (default)
P R O G R A M C O N T R O L
M O D U L E C O N T R O L 1 M 1 0 1
0 0 _ _ _ _ _ _ _ _ I O W 1 M 1 0 1
20-character user-editable custom label
