10
ALARM CLOCK (CONTINUED)
REPLACING THE REMOTE CONTROL BATTERY (CONTINUED)
1.
2.
3.
4.
5.
6.
Gentle Wake
Each alarm type is set to activate with Gentle Wake.
Gentle Wake means each alarm will gradually increase in
volume for a more pleasant awakening.
• If you have selected the TUN (FM Radio) or iPod (iPod/
iPhone/ iPad playlist) alarm types, the radio/ music
alarm volume will gradually increase in a few seconds
of alarm activation.
• If you have selected the Buzzer alarm type, the buzzer
beep sound will increase in speed and volume after
2~3 seconds.
Alarm Snooze Mode/ Alarm Stop Mode
When the alarm is activated, you can press the
Button on the Docking Speaker or the “SNOOZE” Button
on the Remote Control at any time to activate the Snooze
Mode. In Snooze Mode, the alarm will switch off
temporarily for about 9 minutes. After 9 minutes, the
alarm will reactivate again.
To stop the alarm for the current alarm session, press the
Button for over 3 seconds. This will switch off the
alarm until 24 hours later, or until the next set alarm time.
IMPORTANT:
The alarm stops but the alarm settings
remain so the alarm will reactivate after 24 hours, or until
the next set alarm time. You must deactivate the Alarm by
pressing the ALARM Button on the Remote Control to
switch off the Alarm Indicator Light on the LED Display
Screen. This will completely deactivate the alarm, and
stop the alarm from reactivating every 24 hours.
The Remote Control is powered by 1 x CR2025 Button
Cell Battery. When the power has been used up in the
Remote Control Battery, you may replace the battery by
following these instructions:
1. Lock/ Hinge:
Push Right
2. Slide Out
3. Replace
with a new
CR2025
Button Cell
Battery
Battery
Door
Locate the Battery Door located on the Remote Control.
There is a Lock/ Hinge mechanism on the Battery Door to
secure it from opening while using the Remote Control.
To open the Battery Door, use one finger to push the
Hinge toward the middle.
While pushing this Hinge, use your finger from the other
hand to slide the Battery Door out of the Remote Control
body.
The Battery Door should slide out easily to expose the
the Battery Tray holding the CR2025 battery.
Remove the old battery and replace with a new CR2025
battery. Make sure to insert the battery with the correct
polarity by observing the polarity instructions on the
Remote Control.
When the new battery has been inserted correctly into the
Battery Tray, slide the Battery Door back into the Remote
Control body until it is locked back into place.
WARNING
: If there is a leakage from the CR2025 battery,
remove the battery from the device and properly dispose.
Immediately wash any exposed body surfaces, clothing,
or furniture with soap and water. If contact with eyes or
mouth occurs, flush with clean water immediately and
seek immediate medical assistance.
WARNING
: Do not use a different type or size of battery
other than a CR2025 battery.
WARNING
: Do not heat or disassemble the battery. Never
throw the battery in fire or water.
WARNING
: Never recharge the CR2025 battery.
REPLACING THE REMOTE CONTROL BATTERY
BATTERY PRECAUTIONS
EN
