POWER PRESENTER RF
Instruction Manual
The POWER PRESENTER RF remote is a handy, compact presentation tool. It allows you to control slides
in any presentation or slide show software. The Power Presenter RF remote includes a built in laser pointer.
The kit includes: a remote with laser pointer (battery included), a receiver, a USB cable and a nylon
carrying case. The POWER PRESENTER RF uses radio frequency technology, so you don’t have to point
the remote at the receiver to control your slides. The maximum operating distance between the remote and
the receiver is 150 feet, depending upon operating environment.
System Requirements
The only system requirement is USB compatibility. The POWER PRESENTER RF is “plug and play”
compatible with MAC OS 8 or higher and Windows 98, NT, 2000, XP or higher.
Connecting the Receiver to the Computer
For maximum range, the receiver should be placed as far away as possible from any electronic devices.
Using a USB connection (MAC OS 8 or higher and Windows 98, NT, 2000 or higher)
1) Turn on your computer and let it fully boot-up.
2) Plug Type-A end of the USB cable into the USB port on your computer.
3) Plug Type-B end of the USB cable into the USB port on the receiver.
Note:
The Type-A USB port on the receiver is used for connecting additional USB devices
To your computer through your Power Presenter receiver unit.
4)
The computer should automatically recognize the receiver as a new
hardware after about 5 to 15 seconds, depending on the computer.
Follow the instructions for installing new hardware (you may need to
load the necessary USB driver from your operating system disk). Once
your computer has installed the receiver as new hardware it will not need
to run through the same steps again. Next time you plug the receiver into
the same computer, it will take about 5 to 10 seconds to recognize the receiver. During the 5 to 10 seconds
there may be little or no indication that the computer is communicating with the receiver.
Connecting Another USB Device
The USB Type-A, female port (rectangular shaped Usb female connector) on your POWER PRESENTER
RF receiver is connected to an internal USB hub port. This port will allow you to connect other USB
devices to your computer through your POWER PRESENTER RF receiver unit. To use this port, simply
connect a USB device with a Type-A, connector into the port.
Note:
USB 2.0 devices will work at USB 1.1 speeds when connected to this port as the POWER
PRESENTER RF is a USB 1.1 compatible device.
Part # PPRF
