PRIMUS
r
1000 Integrated Avionics System
A28--1146--112--00
9-11
Troubleshooting
MULTIFUNCTION DISPLAY (MFD) CHECKLIST
UPLOAD PROCEDURE
The MFD checklist is stored in each display guidance computer. Table
9--6 is the procedure used to set up the aircraft to access checklists.
Step
Procedure
1
The aircraft must be on the ground and powered up in
standby.
2
Locate the interface plug (located behind the pilot’s seat)
and connect a personal computer (PC) using a RS232
interconnect cable to the plug.
NOTES:
1. The PC must have the checklist programming software and
the correct checklist available for use. Refer to the ECP--800
Programmable Checklist equipment for details.
2. If the PC has Windows
TM
, do not access the ECP--800
software from the Windows
TM
prompt. Instead, use the DOS
prompt to start the checklist software.
3
Apply power to the avionics. Wait for the ADI to become
valid before processing.
4
Using the on--side DC, use the RA (DH) knob to set 890
RA (DH) on the PFD.
5
Push and hold the display controller TEST knob.
6
While pushing in the TEST knob, momentarily push the
display controller’s fourth selection button from the left.
The EFIS momentarily blanks and the following display
appears on the PFD:
NOTE:
Do not follow any instructions on the display. These instructions
are not required actions.
CHECKLIST LOADING
PROGRAMMABLE CHECKLIST
EQUIPMENT IS REQUIRED
SCREEN WILL BLANK
CYCLE IC--600 CIRCUIT
BREAKER TO RECOVER
WHEN READY TO BEGIN:
PRESS PB#1 ON DC--500
MFD Checklist Upload Procedure
Table 9--6 (cont)