10. Insert the center riser board back on the motherboard.
11. Replace the card holder and card retention arm making sure the tab locks into place.
12. Replace the workstation cover and place the workstation in the furniture using the appropriate
installation procedures in section
13. Reconnect all the cables.
14. Restart the operating system.
5.2.2
Inserting the LCNP4E/LCNP4E2 board in slot 2
If the LCNP4E/LCNP4E2 board is located in the PCIe slot 2 of the workstation, use this procedure to
replace the LCNP4E/LCNP4E2 assembly in PCIe slot 2.
To replace/add the LCNP4M board
1. Perform all the tasks described in section
Accessing the components in the workstation
.
2. Disconnect the LCN MAU cable from LCNP4E/LCNP4E2 board.
3. For nVIDIA Quadro NVS 300, remove the DMS59 to DVI dongle.
4. For Extio, remove the fiber optic cable connected to the PCIe card.
5. Remove the side cover of the workstation.
6. Remove the top cover of the workstation, perform the steps mentioned in section
- 44 -
Chapter 5 - Servicing
