Installation
2. Feed the cable through the cable
gland.
3. Turn over the detector module and
locate the terminal blocks on the
back. Remove the terminal blocks by
pulling them toward the center of the
module.
4. Connect the cable to the appropriate
terminal block, referring to the
relevant wiring diagram. Strip and
insert the end of each wire into the
corresponding terminal hole. Using a
flat-blade terminal screwdriver,
tighten the terminal screw until the
wire is secured. Use a ferrule on the
wire where necessary.
CAUTION
Do not over-tighten the terminal screw.
5. Replace the terminal blocks in their
correct positions.
22