Model RA-2000 Installation Instructions
2
P/N 151443 Rev A
7550 Meridian Circle, Suite 100
Maple Grove, MN 55369-4927
763-493-6455 or 800-328-0103
Fax: 763-493-6475
www.silentknight.com
© 2008 Honeywell International Inc.
for backbox knockout locations
Figure 4: Back Box Knockout Locations
3.
Wire the Annunciator board to the main control panel. See
Figure 2.
4.
Attach the annunciator and door assembly to back box as
shown in Figure 5 using the supplied screws.
Figure 5: Attaching Annunciator/Door Assembly to
Backbox
Surface Mounting
The Model RA-2000TG/TR trim ring kit is available for use
when surface mounting.
1.
Remove the desired knock out. See Figure 4.
2.
To properly mount the back box, insert a single screw into
the key shaped mounting hole. Do not tighten all the way.
See Figure 6.
Place a level on top of the back box, with the back
box level insert the rest of the mounting screws.
Figure 6: Back Box Surface Mount Holes
3.
Run wires to the control panel.
4.
Place the trim ring over the back box as shown in Figure 7.
Figure 7: Installing Trim Ring
5.
Attach the Door assembly to the back box using screws
provided.
6.
After the annunciator wiring to the panel has been
completed, replace the electronic assembly in the back box.
Place the bezel over the back box and tighten the set screws
on the bezel.
Wire Knockouts
Wire Knockouts
Wire Knockouts
Key Shaped
Mounting Hole
Back Box
Mounting Holes
firealarmresources.com
