9
PrOGrAmmING YOUr ST9100C
h.
When the required day is indicated, press the green
button to confirm, and
the message ‘MON COPIED’ will be displayed for a moment. The day into which
Mondays programme has been copied is now available to have its programme
edited.
Note:
Once a day’s programme has been confirmed in this way, it now becomes the
day whose programme is copied if the
COPY DAY
button is pressed again.
OR
Programming a Different Day:
i.
Press the
NeXT DAY
button to select the next day, which is displayed along the
top of the screen. The programme for that day can then be adjusted by following
steps
b
–
e
above. Programmes for the remaining days can be set in the same
way, using the
NeXT DAY
button to move to the next day.
exiting Programming mode:
To exit programming mode, move the slider to the
rUN
position. This can be done at
any time during the programming process, and any changes made and confirmed
with the button will have been saved.
Note:
If the unit is left in programming mode for more than 10 minutes without the
slider being moved or any buttons pressed, the message ‘MOVE SLIDER’ will be
displayed. Press a button to finish programming, or move the slider to the
rUN
position.
Disabling / enabling Time Periods
To disable any of the time periods
ON 1
to
OFF 1
,
ON 2
to
OFF 2
, or
ON
to
OFF
,
simply set the
ON
time and its paired
OFF
time to the same time, and the programme
will just ignore them.
To re-enable the time period, simply set the two
ON
and
OFF
times to be different.
