9 - 34
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is not found within this time period, the
data can be either transmitted or discarded, based on the setting you are using for
UPC-A Number System 4 Addenda
Required
or
UPC-A Number System 5 Addenda Required
. Set the length (in milliseconds) for this timeout by scanning the
bar code below, then setting the timeout (from 0-65535 milliseconds) by scanning digits from the
Programming Chart
, then
scanning
Save
.
Default = 100.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
Coupon GS1 DataBar Output
If you scan coupons that have both UPC and GS1 DataBar codes, you may wish to scan and output only the data from the GS1
DataBar code. Scan the
GS1 Output On
code below to scan and output only the GS1 DataBar code data.
Default = GS1 Out-
put Off.
Require Coupon Code
Require Coupon Code or 2 Digit
Addenda
Require Coupon Code or 5 Digit
Addenda
Require Coupon Code, 2 Digit
Addenda, or 5 Digit Addenda
Addenda Timeout
* GS1 Output Off
Summary of Contents for Stratos 2700
