Task
For more information refer to…
Be aware of all power and grounding
requirements for your furniture.
Specific site requirements
Section
Verify pinning for external media drives is
correct
Section
Install the workstation in the furniture
Section
Installing workstation in Icon
Section
Section
Connect device cables
Section
3.2
Power and grounding requirements
The ground connection for Workstation-based nodes is made through the third wire in the AC power
cord.
l
l
Selecting the correct power setting
3.2.1
AC Power warning
ATTENTION
The power supply circuit is connected to AC power when the power cable is connected. The
power control switch on the front panel only enables the power supply circuit outputs.
It is strongly recommended that the power cord be connected to a clean power source with
backup such as an Uninterruptible Power Source (UPS).
3.2.2
Selecting the correct power setting
The workstation platform automatically senses the AC line voltages and therefore there is no
positioning switch to be set. The following table provides the power requirements for the workstation.
Description
DC Power
AC Voltage
AC RMS Current
AC Power
Electronic assembly
N/A
120 VAC
220 VAC
0.991 A
rms
0.599 A
rms
113 Watt
114 Watt
- 27 -
Chapter 3 - Installing