T775U SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLER
62-0255—09
26
Fig. 56. Setup - Outputs - Relay - Reset Runtime.
1.3.4.3. RESET RT
(run time)
This selection displays only if “Show RT = YES” is
selected during Output Options setup (see page 24).
1.
Press the
u
button to display the Reset RT values.
2.
Use the
p
and
q
buttons to select YES or NO.
Default: NO
3.
Press the
u
button to accept the value and return to
the Relay menu.
Selecting YES immediately resets the output run time
hours to zero for this output. When you subsequently
return to this screen, the RESET RT defaults to NO.
NOTE: Run times can be reset to zero for each indi-
vidual relay. You must do this for each relay
that you want to reset to zero.
Fig. 57. Setup - Outputs - Relay - Exit.
1.3.4.4. EXIT Relay Setup
Press the
t
button to exit the selected relay set up and
return to the Outputs menu.
To setup the next relay output go to “1.3.4. Setting up the
When you finish setting up the relay outputs, continue with
1.4. Exiting Setup
Press the
HOME
button to exit Setup mode and return to
the home screen display.
or
Use the
p
and
q
buttons to highlight EXIT from the menu
and press the
u
button.
This completes the Setup procedure.
2. PROGRAMMING OUTPUTS
(MOD AND RELAY)
WITH NO
RESET
The T775U can be programmed for Reset or No Reset.
From the factory, the T775U is programmed for No Reset.
This section describes the steps necessary to program
the controller for No Reset.
NOTE: For applications where Reset is not used,
only one sensor (Sensor A) is available for
use.
SETUP
OUTPUTS
RELAY 1
RESET RT
SETUP
OUTPUTS
RELAY 1
RESET RT
RESET
RUN TIME
FOR
RELAY 1
YES
NO
M24617
SETUP
OUTPUTS
RELAY 1
RESET
SCHEDULE
RESET RT
EXIT
M24618
