44 ซ.บรมราชชนนี 70 ถ.บรมราชชนนี ศาลาธรรมสพน์ ทวีวัฒนา กทม. 10170.
Website:
โทร: 02-888-3472
Line ID: @add11 e-mail: add028883472@gmail.com
DIGITAL BURNER CONTROLLER
TBC2800 SERIES
FEATURES
PRODUCT HANDBOOK
APPLICATION
TBC2800 series is the high-performance burner controller which is de-
signed for commercial and industrial application and suitable for gas
firing.
TBC2800 series can be used for pulse firing and modulating
firing mode.
TBC2800 series applies to multiple burners application, such as steel,
machinery manufacturing, non-ferrous metals, glass, ceramic, petro-
chemical and other industries.
INSTALLATION
TBC2800 can be installed with DIN rail or two M4 screws. While
install-ing with M4 screw, it is necessary to put the sealing gasket
beforehand so as to ensure IP 54 protection.
TBC2800 reserves 7 x M16 holes for cable wiring.
WARNING
Improper operation will cause personal injury or equipment damage!
Disconnect the power connection before installation!
Must consider the electric shock protection! Make sure the end-
users can not access the parts not proper insulated
1
Compatible to UV, Double rod (separated flame rod and
igni-tion rod) and 1 rod (integrated flame rod and ignition
rod) flame detection which can be set manually
Integrate 6 kinds of timing choices which can be set
manually according to the application requirements
24 hours continuous operation (except UV application)
Life-
cycle ≥ 250K times (Note 1)
IP54 protection
field or cabinet installation
Multifunctional LED lights and buttons indicate the
Flame strength, fault & operation sequence and
parameters
Remote or on-site reset
Adjustable flame on-off threshold
Comply with EN298
SPECIFICATIONS
UV sensor C7027A/C7035A/C7044A
CAUTION
Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
Check the ratings given in the instructions and marked on
the product to make sure the product is suitable for the
application.
Installer must be a trained, experienced, flame
safeguard ser-vice technician.
After installation is completed, the operation
parameters should be set by the authorized person
according to the application requirements and this
product handbook.
Keep the flame detector cable and ignition cable as
far as possible.
C7027A/C7035A/C7044A is not the self-checking UV
sensor, so TBC2800 should be restarted once every 24
hours.
Note1: If one rod flame detection is applied, TBC2800 lifecycle will be
100,000 times.
W x D x H:
122.5 x 82 x 131.2mm
Mains input
220/230VAC
–15/+10%
50 60Hz
Power consumption
9 VA
Cable length of flame rod:
75m(max)
Cable length of UV 75m max)
Flame threshold setting
1~10µA
Cover
material
PC/ABS
Protection class
I P54
Ambient temperature
-20
+
Ambient humidity
95%, non condensing
Lifecycle
250,000 cycles comply with EN298
Drive gas valve 1A(max) power factor
1
Drive ignition transformer 2A(max)
PF
0.2
Maximum output for terminal
2A
242Vac
