7
7
B. BATTERY COMPARTMENT
•
Holds two AA-size batteries
C. RESET
•
Resets all previous settings
D. CHANNEL SWITCH
•
Selects the desired channel -1,2 or 3
E. WALL-MOUNT RECESSED OPENING
•
Keeps the remote sensor on the wall
F. °C/°F SWITCH
•
Selects the temperature display in Fahrenheit or Celsius
NOTE: Install the batteries; select the channel and temperature in °C or °F
before mounting the sensor.
BATTERY INSTALLATION
•
Remove the screws from the battery compartment with a small Phillips
screwdriver.
•
Set the channel 1 through 3. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote sensor
is being used.
•
Install 2 “AA” size alkaline batteries (not included) matching the
polarities shown in the battery compartment.
•
Select the temperature unit in °F or °C by pressing
°C/°F
switch with a
paper clip or similar tool
•
Replace the battery compartment door and secure the screws.
•
Secure the remote sensor in the desired location.
MOUNTING
•
The remote thermo-hygrometer sensor can be placed on the flat
surface or mounted on the wall in vertical position
8
•
Use the wall mount hardware and screws when mounting the
thermo-hygrometer sensor on the wall
PLACEMENT
•
The remote thermo-hygrometer sensor should be placed in the area
with a free air circulation and sheltered from the direct sunlight and an
extreme weather conditions.
•
Ideally, place the thermo-hygrometer sensor above the natural surfaces
(such as a grassy lawn).
•
Avoid placing the thermo-hygrometer sensor near sources of heat,
such as chimneys and heating elements.
•
Avoid any areas collecting and radiating a heat from the sun, such as
metal, brick or concrete structures, paving, patios and decks.
•
The international standard for the valid air temperature measurements
is 4 feet (1.25meters) above the ground.
OPERATION
Immediately after batteries are correctly installed, the remote sensor will start
transmitting a temperature and humidity data to the main unit.
WIND SPEED METER
FEATURES
•
Wind speed and wind gust measurement
•
Measurement of the temperature at the place of the wind meter
•
Remote transmission of the temperature, wind speed and gust data to
the main unit via 433 MHz signal
•
Operating range of up to 100 feet (30 meters)
•
Wall or pole mount
