5
MAINTAINING YOUR STAGE 1 WASHABLE PARTICLE PRE-FILTER
REPLACING THE TRUE-HEPA FILTERS
See INSTALLATION INSTRUCTIONS on page 3 of this manual.
You may be able to purchase Honeywell replacement True-HEPA filter
R
A
A
R
for your air purifier at the store
where you purchased your air purifier or they can be ordered directly from Kaz USA, Inc., the licensee of
Honeywell air purifiers at
www.replacementfilters.com
. If you have any questions, contact Kaz Consumer
Services at
1-800-477-0457.
Please note that each model series takes a different number of HEPA filters:
HPA090 and HPA100 Series use 1 HEPA
R
A
A
R
Replacement Filter
,
HPA200 Series use 2 HEPA
R
A
A
R
Replacement Filters
,
HPA300 Series use 3 HEPA
R
A
A
R
Filters
These air purifier models each have two electronic filter checks to remind you
when to check and replace the True-HEPA filters and the Odour Reducing Pre-
Filters based on the air cleaner’s hours of use.
When the True HEPA filter(s) and/or the Pre-Filter need to be replaced, the
“Check Filter” or “Check Pre-Filter” light will illuminate (
Fig. 7
).
You should periodically check these filters. Depending on operating conditions,
the True-HEPA filters should be replaced every 12 months, and the Odour
Reducing Pre-Filters every 3 months, especially if there have been heavy odours
and particles in the home.
To RESET Either Electronic Filter Check:
After you have replaced the appropriate filter(s) the “Check Filter or “Check Pre-Filter” light will remain
on until it is reset. With the unit powered on, press the lighted button and hold for approximately 2
seconds until the light turns off. The electronic filter check is now reset. Depending on individual usage
(environment and hours used), you may need to replace filters more or less frequently.
NOTE: If you change the Pre-Filter or Filter before the Electronic Filter Check lights are illuminated, it is
possible to re-set the light indicators. With the unit plugged in, but NOT powered on, press and hold each
button individually for at least 5 seconds. This will illuminate the indicator light. After the light turns on,
individually press and hold the “Check Filter” or “Check Pre-Filter” button until each light goes off. At this
point, the filter indicator will be re-set to it’s original “clean” status.
These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent
upon the concentration of contaminates going through the system. High concentrations of contaminates
such as dust, pet dander and smoking will reduce the useful performance of the filter.
NOTE:
None of the filters are washable. Do not immerse them in water.
ELECTRONIC FILTER CHANGE REMINDER
Fig. 7 Will illuminate
when it is time to
change HEPA filters
Using the Dimmer Option
(Not available on the HPA060 series, HPA070C series
HPA090 Series)
The Dimmer Option ( ) allows you to adjust the brightness of the LED displays on
the control panel (
Fig. 8
). You may wish to adjust the brightness depending on the
room where the unit is placed. The unit always turns on with the brightness on HIGH.
To adjust brightness
:
• TAP the Dimmer icon ( ) once to dim the lights to LOW.
• TAP the Dimmer icon (
) twice and it will shut the lights OFF. (the air purifier
will not shut off).
• TAPPING the Dimmer icon (
) a third time will return the brightness to HIGH.
Fig. 6 Dimmer Function