43
ACTIVATING OR DEACTIVATING ALARMS
In the
Wind Window
press
ALARM/CHART
to recall
•
Current wind speed
•
Wind speed alarm with the “
ALARM HI”
displayed
•
Wind gust alarm with the
“GUST ALARM HI
” displayed
•
Daily maximum wind speed with “
DAILY MAX
” displayed
If the specific alarm is disabled,
“OFF”
will be displayed; otherwise the alarm value will
be shown.
When the wind alarm is displayed, press the
UP
or
DOWN
to activate or deactivate it.
PROGRAMMING HIGH WIND ALARM
•
In the
Wind Window
, press
ALARM/CHART
to select the desired alarm (wind
speed or wind gust speed)
•
Press and hold
ALARM/CHART
button until speed digit will flash.
•
Set the alarm using the
UP
or
DOWN
. Press and hold either button for fast
digits advance.
•
Press
ALARM/CHART
to confirm your selection and return to the high wind
alarm selection screen.
44
MAINTANANCE
CHANGING BATTERIES
The battery status of each weather sensor is checked every hour. If the low battery
indicator lights up, replace the batteries in the corresponding unit.
CHANGING BATTERIES IN THE MAIN NUIT
•
First connect the AC/DC adaptor provided to the main unit to avoid losing any
data
•
Remove the battery compartment door on the back and replace all batteries.
Do not mix old and new batteries
•
Replace the battery compartment door
CHANGING BATTERIES IN REMOTE SENSORS
•
Replace the batteries following the setup instructions for the corresponding
sensor
•
When the batteries are properly installed, the remote weather sensor will
resume sending signals to the main unit
•
To enforce an immediate remote signals search, press and hold
DOWN
on
the main unit.
CLEANING
The main unit and outer casings of the remote weather sensors can be cleaned with a
damp cloth. Small parts can be cleaned with a cotton tip or pipe-cleaner.
Never use any abrasive cleaning agents and solvents. Do not immerse any units with
electronic parts in water or under running water.
ANEMOMETER
Check if the wind vane and wind cups can spin freely and are free from dirt, debris and
spider webs.
RAIN GAUGE
Checking and cleaning the rain sensor in a timely manner will maintain an accuracy of
the precipitation measurements.
•
Detach the protective screen and lid
•
Clean with soapy water and a damp cloth, removing dirt, leaves or debris
•
Clean small holes and parts with Q-tips or pipe-cleaner
•
Watch out for spiders or insects that might have crawled into the funnel
•
Clean the swinging mechanism with a damp cloth
