Operation
TP1MAN Issue 3 Apr 06 (MAN0630)
31
Control Buttons
The control buttons are located beneath an access panel underneath the display screen.
They are used to cancel alarms and access/navigate the menu system.
To access the buttons carry out the following procedure:
1
Access the controller interior.
See page 12.
Note
The Control Buttons Access Panel cannot be opened until access is made.
2
Push down on the finger grip located at the bottom of the Control Buttons Access panel.
See the subsequent diagram and the diagram on page 12.
3
Slide the panel down to release it.
The panel springs upward and is held in the open position. This provides access to the
buttons.
The four control buttons provide the following functions:
The results of these actions are shown on the display.
Button
Function
In Text
Navigates up through menus and lists and is used to select (highlight)
a menu option. Also used to increment values, e.g. range.
Up
Navigates down through menus and lists and is used to select
(highlight) a menu option. Also used to decrement values.
Down
Enters a menu function. Saves a user setting
OK
Exits/cancels the current screen/option and returns to the previous
screen/option. Acknowledges alarm/fault.
With no gas event reported, press the button once to put the controller
through a self-test routine, see
Cancel
Control Buttons Access Panel
(removed for clarity)
Up Button
OK Button
Down Button
Cancel Button
X
