11
11
•
Allows displaying pressure history records
J.
SNOOZE/LIGHT
button
•
Stops all alarms temporarily
•
Activates a backlight for 5 seconds
K.
Back panel
UP (
▲
)
button
Increases the parameters of pressure and altitude
L.
Back panel
DOWN (
▼
) button
Decreases the parameters of pressure and altitude
M.
Back panel
UNIT
button
When depressed and held activates pressure & altitude units programming
mode
N.
Back panel
PRESSURE/ALTITUDE
button
•
Allows toggling between
SEA LEVEL
pressure,
LOCAL
pressure and
ALTITUDE
modes
•
When depressed and held, enters into the altitude programming mode
O. BATTERY COMPARTMENT
Accommodates 2 (two) UM-3 or AA 1.5V alkaline batteries
P. REMOVABLE TABLE STAND
Holds unit in upright position on a flat surface
Q
.
WALL- MOUNT RECESSED OPENING
Keeps the unit on the wall
BATTERY INSTALLATION
•
Remove the battery compartment door located on the back.
•
Insert two (2) AA size batteries according to the polarities shown and
replace the battery compartment door.
•
When placing the main unit on the table or other horizontal surface,
unfold the table stand adjusting it to the desired viewing angle.
12
•
When mounting the main unit on the wall or vertical surface, remove
the table stand from the unit.
PLACEMENT
•
Make sure that the main unit is locating within the operating range of
the remote sensor
•
Ideally the remote sensor should be mounted within the line of sight of
the main unit.
•
Transmission range may be affected by trees, metal structures and
electronic appliances.
•
Test reception before permanently mounting the remote sensor
Avoid placing the main unit in the following areas:
•
Direct sunlight and surfaces emitting and radiating heat, such as
heating ducts or air conditioners.
•
Areas with interference from the wireless devices (such as cordless
phones, radio headsets, baby listening devices) and electronic
appliances.
OPERATION
The weather forecaster is designed to measure local pressure and calculate
the other two parameters based on the Local Pressure. Sea Level Pressure
and Altitude are interdependent. If you adjust altitude, it will calculate sea level
pressure, if you adjust sea level pressure, it will automatically calculate altitude.
You can only adjust one of the two – either sea level barometric pressure or
altitude.
If you wish to know pressure changes at your
specific location (house)
, the
LOCAL
barometric pressure should be selected In this case, the local
altitude/elevation must be programmed according to GPS readings, Internet,
etc.
If you wish to know pressure changes in your
surrounding metro area
, then
