15
15
MOON PHASE ICONS
PRESSURE MODE
The pressure mode indicates the current local barometric pressure, the sea
level pressure and a moon phase. It also displays barometric pressure value for
the past 36 hours in 1 hour intervals. Pressure can be set in inHG or HPa/mBar
and altitude can be set in feet or meters.
VIEWING PRESSURE AND ALTITUDE INFORMATION
To view a pressure or altitude information, press
PRESSURE/ALTITUDE
button
on the back rotating between the sea level pressure, local pressure and local
altitude screens.
16
PROGRAMMING SEA LEVEL PRESSURE
•
Press
PRESSURE/ALTITUDE
button on the back until the pressure
with “
SEA LEVEL
” mark is displayed.
•
Press and hold
PRESSURE/ALTITUDE
button until the pressure digits
are flashing.
•
Set the sea level pressure by pressing
UP
or
DOWN
buttons. Press
and hold either button for the quick digits advance.
•
Press
PRESSURE/ALTITUDE
button
to confirm selection.
REMOTE AND INDOOR TEMPERATURE & HUMIDITY
After batteries are installed; remote sensor will transmit temperature and
humidity data at 45 second intervals. The main unit may take up to two minutes
to receive the initial readings. Upon successful reception, remote temperature
and humidity will appear next to the weather forecast section of the main unit’s
display (the default remote channel is channel one). The main unit will
automatically update readings at 45-second intervals.
After communication between the main unit and remote sensor has been
established, secure the remote sensor in the desired location.
The wave icon is located above the remote channel number indicates the
reception status from the corresponding remote sensor.
There are three following types of the reception status may be displayed:
The unit is in a searching
mode.
Temperature and humidity
readings are securely
registered.
No signals detected.
- - -
