Using Z-Wave Devices and Scenes (cont'd)
32
Room Setup
A room is a defined collection of different types of Z-Wave devices, which can be used to organize a large number of Z-
Wave devices into smaller, more manageable device lists. Up to 50 rooms can be created with no limitation to the
number of devices in each room.
Room Name
Kitchen
Bedroom
Living Room
Device 1
Kitchen Over Head
Light
Bed. Lamp
L.R. Lamp
Device 2
Kitchen Cabinet Lights
Bed. Fan
L.R. Fan
Device 3
Kitchen Fan
Bed Overhead Light
L.R. Outlet
Device 4
Kitchen
Follow the procedure below to create a Room.
1. Press
Room Setup
>
Add
.
2. Enter a room name > press
GO
.
3. Check the box next to the device(s) that you want
to be controlled in this Room and press
Save
.
4. Select
Edit
to make changes to existing
Rooms; use
Delete
to delete a Room.
5.
If settings were changed, a pop-up confirmation
window displays
“Settings Saved.”
Secondary Tuxedo Controller
After all Z-Wave devices have been added into the
Primary Tuxedo (#1), the device information can be downloaded to a Secondary Tuxedo (#2). Up to 231 secondary’s plus
1 primary controller, for a total of 232. Keep Tuxedos within 40 feet of each other (if it does not work, move the keypad
closer to the primary), apply power to Tuxedo #2 and do the following:
1.
At Tuxedo #1 (Primary Controller): Press
Automation
>
Z-Wave Setup
; the “Z-Wave Device Management”
screen is displayed.
NOTE:
If used for Remote Services, Tuxedo should not be configured as a secondary controller. See the
Remote
Services
section later in this document.
2.
At Tuxedo #2 (Secondary Controller): Press
Z-Wave Primary
(located in the lower right side of the screen). The
icon
changes to an
icon, representing the controller is now in secondary mode.
NOTE
: The message
“Please remove all Z-wave devices from network first”
appears if Z-Wave devices are
enrolled. If no Z-Wave devices exist, a confirmation will display
“Change to Secondary Controller? Note: Total
Connect feature will be unavailable in secondary controller mode.”
Select
Yes
to change this keypad to a
Secondary Controller.
3.
At Tuxedo #1, Press
Add Device
.
4.
At Tuxedo #2: Press
Add Device
.
“Secondary Controller Inclusion Devices Upload in process.”
When
device information from the Primary Tuxedo is downloaded to the Secondary Tuxedo:
Example 2: Screen Interface
Example 2: Assigning Devices
