4 - 9
Presentation Mode
Presentation Mode uses ambient light to detect bar codes. The LEDs remain
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code. If the light level in the room is not high enough, Presen-
tation Mode may not work properly.
Note: If you are using a cordless charge base in Presentation Mode, the battery
will not charge unless the power supply is plugged into the base’s
auxiliary power port.
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LEDs dim 30 seconds after a
bar code is decoded. If you wish to dim the LEDs immediately after a bar
code is decoded, scan the
LEDs Off
bar code, below.
Default = LEDs On.
Presentation Sensitivity
Presentation Sensitivity is a numeric range that increases or decreases the
scanner's reaction time to bar code presentation. To set the sensitivity,
scan the
Sensitivity
bar code, then scan the degree of sensitivity (from 0-
20) from the inside back cover, and
Save
. 0 is the most sensitive setting,
and 20 is the least sensitive.
Default = 1.
Presentation Mode
* LEDs On
LEDs Off
Sensitivity
Summary of Contents for XENON 1900
