5 - 5
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may
be placed between the transmission of each character of scanned data.
Scan the
Intercharacter Delay
bar code below, then scan the number of
5ms delays, and the
Save
inside
the back cover of this manual.
To remove this delay, scan the
Intercharacter Delay
bar code, then set the
number of delays to 0. Scan the
Save
bar code using the
inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments)
may be placed after the transmission of a particular character of scanned
data. Scan the
Delay Length
bar code below, then scan the number of
5ms delays, and the
Save
inside
the back cover of this manual.
Next, scan the
Character to Trigger Delay
bar code, then the 2-digit hex
value for the ASCII character that will trigger the delay
To remove this delay, scan the
Delay Length
bar code, and set the number
of delays to 0. Scan the
Save
bar code using the
inside the back cover of this manual.
1
2
3
4
5
Intercharacter Delay
Prefix
Scanned Data
Suffix
Intercharacter Delay
Delay Length
Character to Trigger Delay
Summary of Contents for XENON 1900
