Honeywell Process Solutions
Wireless Dual Analog Input Interface Transmitter
Rev. 8
User Manual
33
July 2012
Section 7: Configuring the Process Variable
This section helps the user in the selection of engineering units, as well as
discussing the setting of a measurement offset and trimming the process
measurement. The subsections are as follows:
7.1: Selecting Units of Measure
7.2: Setting a Measurement Offset
7.3: Trimming the Measurement (Entering a 22-Point Curve)
7.1: Selecting the Units of
Measure*
The Transmitter can be used in many different types of applications. To
accommodate these various options, there are various engineering units
that can be selected. Options include: Volts (WI552 only) and Milliamps
(WI551 only).
Please note that the units selected apply to both Input 1 and Input 2. Each
input may not use different units.
To select units of measurement, follow the Transmitter menu map shown
in Figure 7.1. The factory default units is Volts/Milliamps.
Figure 7.1: Menu Map to Units Setting
If you have the Wireless Management Toolkit software this menu option
will not be accessible via the Transmitter once the Transmitter detects that
the software is being used (See Appendix A for more details). The process
variable units should be entered using the Wireless Management Toolkit
software. To do so, enter the configuration menu (See Section 9.2 of the
Wireless Management Toolkit User Manual). Once in the configuration
menu click on the
General
tab to bring up the general information as
shown in Figure 7.2.
To select the units, click the drop down box labeled
Input Units
. Select
units you wish to use from the available list.
Once a valued has been entered, click
OK
to save and download the con-
figuration changes to the Transmitter.
Figure 7.2: Units Selection Using Wireless
Management Toolkit
* Indicates that Menu is Disabled if Wireless Management Toolkit is detected. (See Appendix A)
Summary of Contents for XYR 5000 Series
Page 2: ......