Honeywell Y9120W Sundial RF2 Pack 4, User Manual

9

PROGRAMMING YOUR  ST9120C

Reviewing the Programme Times

To review your programme, move the slider to the 

PROGRAMME

 position. 

To review the programme times, press the   button repeatedly. The appropriate 

ON

 and 

OFF

 markers will be displayed to show you which time is being reviewed. 

Any of these times can be adjusted by using the   

 or   buttons, and then 

confirmed using the   button. Remember to return the slider to the 

RUN

 position 

after reviewing is complete.

Modifying the Programme

The programme has three pairs of 

ON/OFF

 switching times per day. Each time can 

be set between 3.00 am and 2.50 am (on the next day) to allow you to programme to 

stay on past midnight, if required. 

a.

  Move the slider to the 

PROGRAMME

 position. ‘SET PROGRAMME’ will show 

briefly to verify this action.

b.

  ‘SET ON-TIME 1’ will then be displayed and the time setting for the first 

ON 1

time for 

MONDAY

 will now be flashing to indicate it can be changed. If you do 

not wish to change the time, press the green   button and move to the next 

step. If you do wish to make a change, use the     or   buttons to change 

the first 

ON 1

 time. Each press of the button will change the time by 10 minutes. 

As soon as the time has been changed, the message ‘ON-TIME 1 OK?’ will be 

displayed. Press the green   button to confirm the time is correct and move to 

the next step. ‘SAVED’ will be displayed for a moment to confirm that any change 

has been saved to memory.

DAY/TIME

PROGRAMME

RUN