white wire from LED lamp
blue and grey wire from LED lamp
N04
N05
N06
red wire from battery box
black wire from battery box
K20
K21
Attention: Please keep the instruction for future enquires after installation.
Installation of dust proof cover
(For updated version, the parts need to be purchased separately)
Scale 1:10
N04
Transparent
cover
0.15*25*33 1piece
1. Tear off kraft paper of each
piece of transparent cover.
2.Paste
N04,N05,and N06 together to complete the dust proof cover as shown.
Statement: the lamp wires cannot be
inserted into the output socket.
– – Can use 7 batteries
– – Please notice the place of anode
and cathode when pit in the batteries
– – Rechargeable batteries are not blunt electricity
– – Rechargeable batteries can only be charged
under adult supervision
– – Rechargeable batteries should be
removed from the toy before charging
– – Different types of batteries cannot mix;
Do not mix new batteries in use with semi-used
batteries.
– – Run out of battery should be removed from the toy
– – The power shall not be short circuit
Twist the following wire together:
(I) BLACK wire from the battery box with the WHITE
wire from LED bulb.
(II) RED wire from the battery box with the GREY
wire and blue wire from LED bulb.
Roll and seal the duly twist copper with
the white tape K21 provided.
Place the battery box in the allocated space.
Scale 1:10
N05
Transparent
cover
0.15*22*33 2pieces
Scale 1:10
N04
Transparent
cover
0.15*22*24.7 2pieces
Photo of Dust proof cover
