Hongda USA 13849, Instruction Manual

1

Making tips

1. LED wiring indication: 
White=Positive;Grey=Negative.
2.Use a craft blade to carefully 
skim over the plastic to bare the
 copper wire.
3. For LED wiring extension, 
please refer to the below steps:

Twist the copper of 
both LED wire and 
extension wire together.

Do the same on the 

white wire. 

Remarks: Tie a knot

 at the end of the grey 

wire to differentiate 

the polarity.

Place the duly twist 
wire on the tapes 
provided.

Roll and wrap the wire.

Place another wire 
next to it.
Remarks: DO NOT 
contact both copper
 wire to avoid short 
circuit.

Roll and wrap it together.

LED 

wire

Extension

  wire

LED 

wire

Tips for assembling

1.Picures shown on the package may 
be slightly different from the actual 
product.
2.Please use the provided tracing 
paper  for cutting purpose to achieve
 the best  outcome.
3.Product designs and specification 
may be subject to change without 
advance notice for purpose of
 making  improvement.
4.Testing  on LED function:

DO NOT contact the LED 
wire end direct to the 
battery cell.

Use the provide battery 
holder. Make sue the correct 
polarity.

Warnings

The product is not suitable for children

 under 14 years old. The should be under 

custody of adults when playing with the 

product.

There are small parts, please do not swallow

 them for avoiding dangerous accidents.

Please also play attention to the sharp-

pointed materials to avoid injuries.

How to assemble the battery holder

1.Material and tools needed:

- Battery holder, LED bulb, 

tape, screw driver and 2 piece

 AA size battery(not provided)

2. Use screw driver and 

take the lid off from the

 battery holder.

3. Insert the battery take 
notes on the polarity.

4. Connect the red wire to 

grey wire. Connect the black 

wire to white wire.

5.Wrap the exposed wire 
with the tapes.

6. Place the box lid and 

fastness with screw driver.

Scissors: 
Can be used 
to cut printed 
paper,
 cloth,etc.

Screw Driver: 
For fixing screws,
mostly can be used
 to install doors and 
music components.

Tweezers: 
For holding small
materials and 
rolling up iron wire.

Cutter kinfe:
For peeling off 
power wire skin
and cutting off 
materials.

Ruler: 
For measuring 
materials to identify
the number of 
materials so as to 
enhance work
efficiency.

Self-provided tools

“-”negative

“+”positive