Shepherd 210A Installation Manual V1.1
©
©Copyright 2004. Hongda USA Inc.
15
B
Screws
Cable
Put Spring
Square
Axel
Fig 10
Fig 11
4.5 Install Inside Section of Lock
1. Plug in the
Cable
(Fig. 11) to the one connector available on the circuit
board.
2. Put the little
Spring
into the square axel hole on the inside of the
Outside Section, then insert the square axel into the hole, pushing
against the spring.
3. Turn deadbolt finger knob until the slot lings up with the torque bar and
push into place.
4. Work the Inside Section into place. Make sure the cable doesn’t block
the way for
C
Screws.
5. Fasten Inside Section in place by replacing the two small
A
Screws on
the side of the unit. (Fig. 12)
6. Fasten the two long
C
Screws on the lower portion of the unit. (Fig. 13)
Note:
Don’t fasten screws too tight before final checkup.
