3 Install Latch, Deadbolt and Strikes
3.1 Install Latch and Deadbolt
Insert the lock bolt into the hole,
mark the frame lines of foil board.
The frame lines should be parallel
with the door edge.
Dig a support notch 1/8” in depth.
The notch edge lines should be
parallel with the door edge.
Insert latch and deadbolt, and tighten
the screws (the slanted plane of latch
should face the door closing
direction, and the UP mark of the
deadbolt should point up).
After the screws are tightened, the
foil board should be exactly in the
door center and parallel with door
edge.
Shepherd 210A Installation Manual V1.1
©
©Copyright 2004. Hongda USA Inc.
10
