2.
Mechanical Inspection
Inspect the front and rear of the equipment for shipping
damage. Make sure the equipment is clean, and no
connectors are broken, damaged, or loose. If
equipment appears to be damaged or defective please
contact us for assistance.
3.
Special Attention
(i) The installer must comply with electrical safety
standards. There must be sufficient space between
the camera's power supply and video line and any
high voltage equipment and/or cables.
(ii) To help ensure the camera's life and proper
operation do not point the camera towards the sun
or strong light.
(iii) Do not install the camera in an environment where
the temperature is too high or too low,
recommended operating temperature is 14F ~
122F.
(iv) Do not install the camera near a magnetic field or a
high-power motor.
(v) Only use a dry cloth to clean the camera. If there is
dirt that is difficult to remove, wipe gently with a mild
detergent. Never use strong or abrasive detergents.
(vi) A 12V DC 1A or 2A power supply must be used. AC
power cannot be applied. AC power will damage the
camera and void warranty. Power supply output
voltage, current, voltage polarity and operating
temperature must match requirement of this
equipment.
