_________________________________________________________________________________________________
______________________________________________________________________________________
U326_UVAintAS102_B_e_210316
9/15
7.2.6
LCD display in housing cover (optional)
The flat ribbon cable with 10-pin connector should not be plugged in or out when live! Risk to
persons and equipment!
Visible are the readout potentiometer for the contrast of the LCD display, the reset button for the quantity
counter, the ST1 and ST2 jumpers (see under 8 Functional Description).
7.2.7
Analog output t (temp) (optional)
The initial value x °C (4 mA) and the terminal value y °C (20 mA) are permanent hardware settings and
recorded in the Technical Data Sheet.
The negative terminal of the analog output t (terminal 9) is on the same potential as the negative terminal
of the analog output v (terminal 5).
The analog output signal t is not used in the UVA (e.g. for conversion to standard values).
Abb. 2: LCD display connection with cover open
4-20 mA
Resistance max. 200 Ohm
