6
ENGLISH
Next step is to fix the aluminium landing gear to the fuselage,
4pcs of M4x20 screws with shims and locking nuts.
Place the fuselage on a plane table and adjust the wheel pants
on both sides, that they are parallel to the fuselage.
Now drill a hole through the bore uppon the locking nut of
the wheel shaft. Use a 1,5 mm driller.
Fix the wheel pant with the 10 mm woodscrew.
RUDDER ASSEMBLING
Put a little bit silicone oil into the pivot point of the hinge,
that no glue goes inside the axis. Glue the hinges with 5 min
epoxy into the rudder. Take care of the correct direction of
the hinges. Bend the hinge to 90 degrees, so you can find the
correct position very easy.
Take the shorter fiberglass levers and glue with 5 min epoxy
into the slots of the rudder. With a tape arround the slot you
can prevent the rudder of glue spots.
Summary of Contents for FLW4090
Page 15: ...15 ENGLISH NOTES ...
