13
WARNING
A thermal cut out switches off the cleaner to prevent overheating
if it is used when full or there is a blockage or dirty filters. If
this should happen switch off, unplug and correct the fault.
It will take approximately 30 minutes for the cut out to
automatically reset.
IMPORTANT
DO NOT RUN OVER THE POWER SUPPLY CORD
AS THIS COULD DAMAGE THE SUPPLY CORD
INSULATION.
User checklist
If your cleaner is not working properly run through the
following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with fine dust?
To empty the dust container see instructions on P9.
3. Is the hose blocked?
To clear a blockage see instructions on P11.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P11.
5. Are the filters blocked?
To clean filters, see the instruction on P10.
6. Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p6.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on p11.
8. Has the cleaner overheated?
If so, it will take about 30
minutes to reset.
GB
Freerounder_EN_FR_IT_DE_Draft2.indd 13
03/09/2008 17:35:33
