Warning:
Always switch off and unplug the Hard Floor Polisher from the electrical socket before
assembling, opening or emptying the bin, or before connecting/disconnecting the attachments.
OPERATION
OPERATION
4
Assembling your Floor Polisher
3
Insert the lower section of the handle into the
aperture at the top of the head and screw the
collar in securely.
Changing the pads and plates on your product
Invert the cleaning
head so that the drive
hubs are accessible.
Place the required
hook and loop
backing plate
(for pads) or brush
plate over the hub,
making sure the four
connectors are aligned
to the holes in the hub.
Press the plate down
to clip into place.
Simply pull the
plates/brushes off to
remove and change.
Coral and scrubbing
pads can be applied
directly to the velcro
backing plates and
peeled off to remove.
Important:
Always use two plates/pads of the same type.
Adjust the height of
the handle to suit your
needs by pulling on the
extension button.
Adjusting the handle
For additional stability the pro-grip handle can
be opened to enable two-handed use.
Important:
Please test Hoover Floor Polisher on a small area of flooring before use, please do not
continue use if any damage is caused during the test.
Turning on and off
Insert power plug
into mains socket.
Place your foot on
the base and pull the
handle back to turn on.
To switch off, return
the handle to upright
position and fix
into place.
Push the plastic upper
handle section until
the metal button clicks
into place. Ensure the
handle is attached
securely prior to using.
