Contact Customer Care 1+(619) 449-2392
|5
Charge & Power Protection:
1. Please turn off the power switch before charging.
Hover Cleaner
TM
will not run
(power up) while charging.
2. Hover Cleaner
TM
has circuit protection while charging.
3. Plug Battery Charger into Main Body of Hover Cleaner
TM
and ensure Battery
Charger Plug is inserted all the way into Main Body.
4. Charge light on Main Body will glow red while battery is charging and turns off
when fully charged. Charge time is approximatively 4-5 hours.
How To Use:
1. To clean a surface with the Hover Cleaner, wet the microfiber pads with water or
your preferred cleaning solution. The cleaning solution may be applied or sprayed
directly onto the surface you are cleaning. Always refer to the cleaning solution
manufacturer instruction to determine if their solution is safe to use on the surface you
are cleaning.
2. Note - the Main Body of the Hover Cleaner™ cannot be submerged in water or
other liquids.
3. To adjust the handle length, press the Adjustment Button and move to your desired
length.
4. Clean and dry the Pads after each use.
5. a. Place the Microfiber Pads in the Mesh Washing Bag and place in the washing
machine on normal cycle, let air dry.
b. Rinse the dark green scrubber pads with cool water to clean. Do not put in
washing machine.
Frequently Asked Questions:
1. Q. If the Hover Cleaner
TM
rotates slowly or stops working.
A. It is time to recharge the battery.
2. Q. The Hover Cleaner
TM
rotates unevenly.
A. The Microfiber Pads are installed incorrectly.
3. Q. The Hover Cleaner
TM
doesn’t work on a full charge.
A. Check the Electrical Connector on the end of the Main Body inside the
Aluminum Telescopic Pole.
4. Q. The Hover Cleaner
TM
doesn’t clean floor properly.
A. Replace the Microfiber Pads.
5. Q. Can I purchase replacement Microfiber Pads?
A. Yes. Call Customer Care and order at: 1+(619) 449-2392.
6. Q. Can I purchase a new Battery?
A. Yes. Call Customer Care and order at: 1+(619) 449-2392.
7. Q. When I plug in the charger the red charging light does not come on.
A. Check that your battery is securely connected, it can come loose. First unscrew
the battery compartment, disconnect the battery cord, reconnect the battery
cord, and re-screw on the battery compartment.
8. Q. If I apply too much pressure the heads on the Hover Cleaner
TM
stop rotating.
A. This can be due to low batteries or a tripped safety circuit breaker. Simply turn the
unit off then back on to reset.
If your specific question or issue is not listed above, please contact Customer Care at
1+(619) 449-2392.
Do not disassemble the main body or the handle of the Hover Cleaner
TM
for any
reason, unauthorized disassembly will void all warranties.
