- 13
If the cooking zone is used without a pan or with an unsuitable pan:
the display shows . The zone does not start. If no pan is detected after 10
minutes, the starting operation is cancelled.
To stop the cooking zone, you must stop the hob normally, you cannot just remove the
pan.
IMPORTANT: the pan detector does not work as the hob on/off button.
• PROGRAMMING A COOKING ZONE
Every cooking zone can be programmed for a maximum time of 99 minutes.
Only one zone, at a time, can be programmed.
. Start the required zone by following the previous instructions.
The control LED near the heat level must be displayed, it shows that the zone is live.
. Press the Timer button.
The zone mark around the timer display shows the controlled zone.
. Press the button
to select the time
in minutes.
This is saved automatically after three seconds.
The programmed time can be modified at any moment by pressing the timer
selection button, the timer control LED must be on.
When the time has run, the cooking zone goes off automatically and an audible beep
sounds for 1 minute. Press any button to stop it.
The programmed time can be reset to using the button or pressing the
and buttons at the same time, the cooking zone is then no longer linked to the
timer but stays operational. So you will have to stop the zone independently.
The timer can be used alone as a reminder, it will ring at the end of the
programmed time.
