background image

7

7

Chapter 2.3 - Vertical Shot of Steam

Chapter 2.4 - Automatic Anti-Calc Function

Chapter 2.5 - Automatic Anti-Drip Function

Chapter 2.6 - Self Clean Function

When the iron temperature is set to steam setting vertical steam can be used.
Simply hold the iron vertically, positioned in front with a slight distance from the item 

to be steamed, and press the steam boost button.

aTTEnTiOn: 

Do not aim iron at face, towards yourself, or anyone else while using or 

adjusting steam. Burns or serious injury may occur.

nOTE:

 This is especially useful for getting wrinkles out of hanging clothes, curtains, 

wall hangings etc.

Your iron contains an anti-calc cartridge to reduce scale deposits. This considerably 

prolongs the operational life of your iron.
The anti-calc cartridge is an integral part of the water tank and dose not needs to be 

replaced.

Your iron has anti-drip function. The iron automatically stops generating steam when 

the temperature is too low to prevent water from dripping out of the soleplate.

Use the self clean function once every two weeks. If the water in your area is very 

hard, the self clean function should be used more frequently.
Make sure the iron is unplugged.
Set the steam control knob to position “0”.
Fill the water tank to the maximum level.
Put the plug in the wall socket.
Select the maximum ironing temperature.
Unplug the iron when the temperature has reached.
Hold the iron over the sink, press and hold the self clean button and gently shake the 

iron to and fro.
Release the self clean button after 5-10seconds.
Repeat the self clean process if the iron still contains a lot of impurities.

Chapter 2.2 - Spraying

Ensure there is enough water in the water tank.
Press the spray burst button to produce a fine spray of water nozzle and continue 

ironing.

nOTE: 

Do not spray silk.

Only use the steam boost button when the steam iron has reached the steam or 

maximum temperature.
Do not press this steam boost button more than 3 times repeatedly . For optimal steam 

output, leave an interval of at least five seconds between pressing the steam boost 

button .

Summary of Contents for IRONjet












Reviews: