2
A. Variable Steam Dial
B. Steam Ready Indicator Light (Green)
C. On Indicator Light (Metallic Red)
D. On/Off Button
E. Carry Handle
F.
Water Tank Lid
G. Tool storage
H. Cleaner Main Body
I.
Connector Cover
J.
Extension Tubes (3 PCS)
K. Floor Head
L.
Floor Head Cloth (x1)
M. Floor Head Connector
N. Cloth Mounting (x1)
O. Window Squeegee / Upholstery Tool
P1. Metal Brush
P2. Angled Nozzle
P3. Small Round Brush
P4. Large Round Brush
P5. Scraper Tool
Q. Concentration Nozzle
R1. Funnel
R2. Measuring Jug
S. Steam Handle
T. Hose
U. Steam Trigger
V. Safety Latch
W. Extension tube release latch
GETTING TO KNOW yOUR CLEANER
ASSEMBLING yOUR CLEANER
Remove all components from the packaging.
1. Attach the hose to the main body of the cleaner.
[2]
2. Attach the extension tube to the hose handle. Connect the other extension tubes
together.
[3]
3.
Attach the floor head connector to the floor head. Rotate the connector in place.
[4]
4. Attach the extension tubes to the connector until it clicks in place.
[5]
5. Ensure the handle safety latch is locked.
[6]
NOTE:
To remove the extension tube from the handle or the floor head from the tubes,
press the release latch and pull apart.
USING yOUR CLEANER
BEFORE YOU BEGIN CLEANING
1. Remove the clean water lid by pushing down and turning anti-clockwise.
[7]
2. Fill the measuring jug no more than the M
ax fill line.
3.
Insert the funnel into the water tank and fill the unit with water.
[8]
4. Replace the lid by pushing down and turning clockwise.
5. Ensure the handle safety latch is locked.
[6]
IMPORTANT: Always unplug the cleaner and press the steam release trigger to
release any remaining steam pressure before adding water.
Once the boiler has cooled down you can then remove the water tank cap by pressing
down and rotating the cap in an anticlockwise direction. PLEASE ENSURE NO STEAM
IS EMITTED WITH THIS ACTION !!! IF SO STOP AS THE BOILER IS NOT FULLy
COOLED.
Steam cleaning hard floors
1.
Ensure the floor head is connected to the extension tube.
2. Plug the steam cleaner into the main power and switch on. The red ON light will
illuminate.
[9]
3. After a few minutes the green Steam Ready light will illuminate indicating the cleaner
is ready for use.
[10]
4. Release the steam handle safety latch.
[11]
5. To produce steam press the Steam Trigger Button.
[12]
6. If necessary adjust the variable steam dial to adjust pressure.
[13]
7. Move the cleaner slowly backwards and forwards paying particular attention to high
traffic areas.
GB
