ASSEMBLING YOUR CLEANER
The cleaner should be switched off and disconnected from the mains
supply before you start to assemble.
1. Connect the hose body connector to
the cleaner.
2. Connect one end of the wand into
the hand piece.
4. Fit the other end wand into the all
purpose floor head making sure of a
firm fit.
3. Extend or reduce the length of the
wand by moving the slider in or out
until the desired length is obtained.
5. You can vary the amount of suction
by moving the finger tip control.
6. Extend the power cord no further
than the yellow mark.
6
Red Mark
Yellow Mark