13/14
６．Requirements to end product
This module must be integrated only by OEM integrators under the following
conditions.
(1) OEM integrator has to be aware not to provide information to the users
regarding how to install or remove this module in the user s manual of the end
product which integrate this module. Installation by end users is strictly
prohibited.
(2) Antenna
OEM integrator shall use this module without any modifications including antenna.
If module integrator uses a unique antenna, the FCC certification is required
for the end product.
OEM integrator must make sure that 20cm minimum separation is maintained between
users and the antenna.
(3) Co‑location.
This module must not be co‑located or operated in conjunction with any other
antenna or transmitter. The module integrator shall obtain FCC approval for the
end product, if the module is used for co‑location operation.
(4) Markings
To satisfy FCC/IC exterior labeling requirements, the following text must be
placed on the exterior of the end product.
Contains Module FCC ID: RQZHP3‑1500A, IC: 8406A‑HP31500A
Any similar wording that expresses the same meaning may be used.
(5) Caution to user for modification
The following caution is expressed on the user s instruction manual.
The changes or modifications not expressly approved by the party responsible for
compliance could void the user s authority to operate the device.
