3. Inverter interface panel
When plugged into shore–power, the “ac in” and one of the three battery
status lights will be illuminated in the status bar. Under the control heading,
the “charge” light will be illuminated.
TO USE THE INVERTER:
1.
Start the yacht's engine; bring the rpm up to 1400.
2.
Press the “invert” button under the control section of the panel. The green
light on the switch will then illuminate.
3.
All of the 110v outlets are now live.
4.
Reverse steps 2 & 3 to switch off the inverter, but run the engine for ten
minutes after the inverter is switched off, and check the battery levels 15
minutes after the engine is turned off.
Always ensure that you have switched the inverter off by checking that the
switch on the panel is no longer illuminated. Leaving the inverter on will
cause your batteries to rapidly lose their charge.
Battery status
lights
Charge
button
Invert
button
AC In
